Neoprene Synchronous Belts
neoprene-synchronous-belts
Stock timing belts are listed below. They have fiberglass tension members, neoprene body with nylon covered teeth, all bonded together for maximum strength.
For non-stock widths, Jason cuts specified widths from our large supply of timing belt sleeves on special order.
Mini-pitch MXL (0.080-inch pitch) timing belts are also available.
Jason timing belts are specified by belt length in inches times 10, belt pitch code and a three-digit belt width code which is the decimal inch-width multiplied by 100.
Any width available from stock, consult Jason for pricing. /Asset/jb-7-belts-rubbertiming-WEB.jpg
Double sided belts afford power transmission from either side of the belt and are often used in reversing and serpentine applications.
They are specified the same way as timing belts except with a "D" prefix. For example: D240H100. Special widths are cut to order from our sleeve stock for fast delivery.
Double sided timing belts are produced using the same materials as single sided belts, except that the backside is ground from a fiber reinforced special rubber compound. There is no nylon facing on the backside. Power take off on the backside is limited to 50% of the total catalog rating.
Total belt rating is the same as for single sided belts.
Teeth with nylon facing should always be against driver pulley. /Asset/JB-7-belts-3-WEB.jpg
Standard Timing Belts
(695) Oil, heat and abrasion-resistant.Stock timing belts are listed below. They have fiberglass tension members, neoprene body with nylon covered teeth, all bonded together for maximum strength.
For non-stock widths, Jason cuts specified widths from our large supply of timing belt sleeves on special order.
Mini-pitch MXL (0.080-inch pitch) timing belts are also available.
Jason timing belts are specified by belt length in inches times 10, belt pitch code and a three-digit belt width code which is the decimal inch-width multiplied by 100.
Any width available from stock, consult Jason for pricing. /Asset/jb-7-belts-rubbertiming-WEB.jpg
Double Sided Timing Belts
(293) Neoprene fiberglass reinforcedDouble sided belts afford power transmission from either side of the belt and are often used in reversing and serpentine applications.
They are specified the same way as timing belts except with a "D" prefix. For example: D240H100. Special widths are cut to order from our sleeve stock for fast delivery.
Double sided timing belts are produced using the same materials as single sided belts, except that the backside is ground from a fiber reinforced special rubber compound. There is no nylon facing on the backside. Power take off on the backside is limited to 50% of the total catalog rating.
Total belt rating is the same as for single sided belts.
Teeth with nylon facing should always be against driver pulley. /Asset/JB-7-belts-3-WEB.jpg
